Buy networking Switch in uk is one of the most intricate procedures when setting up a connectivity system. It involves dealing with long tricky names, comparing different options, and essentially finding the right stacking key module for your business requirement.
The X series of Cisco 2960 allows the stacking of up to 8 devices providing a compact and efficient network system. These devices must all have the same Cisco IOS software image to connect. Enough said! Let’s explore the different stacking modules.
Points to be noted.
- You can use the ‘show inventory’ command to make sure the device has been stacked correctly.
- Certain restrictions apply when stacking 2960-X with 2960-S devices.
- The device limit is reduced from 8 to 4 and there is a negative bump in the bandwidth and stack convergence time.
- The entire system falls back to the older gen FlexStack capabilities.
Types of key modules available.
The series offers three distinct stacking options namely:
FlexStack Plus Module.
FlexStack was the original module for the previous generation 2960-S series. The Plus module is launched particularly with the newer series and brings great improvements to its successor.
This is the recommended FlexStack module specially tailored for the X and XR series. It has a dedicated slot on the device and automatically lines up all the IOS versions on the various devices. It offers the maximum bandwidth of 80 Gbps, with stacking being done on copper. The cable lengths range from 0.5m to 3m.
FlexStack-Extended Fiber Module.
As the name suggests this package offers a wider range of connections. Over longer distances, the bandwidth drops to 40 Gbps. The stacking can be done over different floors and even buildings provided they are in the same vicinity.
The ability to reach greater distances depends upon your optical cable choices. Nevertheless, this is an improvement over the older generation 2960-S series which in comparison doesn’t allow for stacking over greater distances.
Flex Stack-Extended Hybrid Module.
The FlexStack-Extended hybrid module is comprised of one SFP+ port and one copper FlexStack-Plus port. The SFP+ port allows for stacking over long distances to occur, whereas the copper port permits us to stack switch with FlexStack-Plus.
The module aims at providing higher bandwidth over greater distances combining the Extended and Plus options. The SFP+ ports have supported transceivers that are chosen appropriately based on the distance between the switches.
The FlexStack-Extended hybrid module permits a combination of existing and new switches spread across different floors of a building or different building of the campus.
In conclusion, each of the Cisco 2960X stack modules has been tailored for different case scenarios faced by different users. The Cisco Catalyst 2960X stacking has always remained a hot topic, but what it boils down to at the end is knowing the types of modules and which of the key stacking modules of the 2960X switches is the most suitable for your needs; an example of could be the short-range high bandwidth stacking provided by the C2960X-stack. Buy data storage drive in USA from gracileit